Skip to content
Çilek Havuz

// Saudi Arabia · hammam and steam room

Hammam and steam room construction in Saudi Arabia

Çilek Havuz builds Turkish hammams and steam rooms for villas, hotels and wellness centres in Saudi Arabia: the marble and steam equipment are made in our workshop in Turkey, shipped by container to Jeddah or Dammam and installed by our own crew, with separate men's and women's suites where the brief asks for them.

Turkish hammam under a gilded dome, with a marble platform and onyx basins
28+
years in the trade
14
Export Countries
15
wet-area services
4
regions covered

Floor plan in, layout back

Send a plan, the number of users and whether you need separate areas. We reply with a layout and a scope.

// 01 · From plan to handover

How a Saudi hammam project runs

Certificates and drawings run in parallel, so the container leaves Turkey with its customs file ready and our crew arrives on a fixed date.

  1. Hammam with grey marble walls and basins, Alibeyköy, Istanbul (Turkey)

    Brief and drawings

    You send the floor plan, the number of users and whether separate areas are needed. We reply with a layout and a scope.

  2. Hammam platform in veined marble, Yalova (Turkey)

    Site survey

    A technician checks the room, drainage, power and ventilation routes, and the design is fixed.

  3. Brass tap over a carved marble basin, Istanbul (Turkey)

    Certificates and production

    Conformity registration starts while the marble is cut and the equipment is tested in Turkey.

  4. Marble basin and bench in a hammam, Istanbul (Turkey)

    Container to port

    Crates are packed in fitting order and shipped to Jeddah or Dammam with the customs file ready.

  5. Finished hammam with arched tile panels, Hereke, Kocaeli (Turkey)

    Installation and training

    Our crew installs and commissions the hammam, then trains the people who will run it.

Hammam and steam room construction in Saudi Arabia: Hammams and spas we built in Turkey

Hammams and spas we built in Turkey

06 media

// 02 · Numbers to know

Six figures behind a hammam in the Kingdom

Climate averages and typical room conditions we check before drawing a hammam in Riyadh, Jeddah or the Eastern Province.

Riyadh, July high

43°C

How hot is Riyadh in summer?

The July average high is about 43 °C. Villas are cooled hard, so the hammam needs its own insulated envelope.

Request a quotation
Marble hammam with a central platform and basins

// 03 · Before you start

Hammam construction in Saudi Arabia: what decides the project

Heat, humidity, privacy and paperwork shape a Turkish hammam in the Kingdom more than the choice of marble.

Written by Ali SAVAŞ

Heat and humidity

Riyadh is hot and dry, with July highs around 43 °C and very little rain, so the hammam sits inside a building that is already air-conditioned hard.

  • That means the steam room needs its own insulated envelope and vapour barrier, or the cold wall behind it will sweat.
  • Jeddah and the Eastern Province are humid as well as hot, and extract ventilation must be sized to clear moist air without pulling it through the rest of the villa.
  • On the Red Sea coast, salt air and saline groundwater call for stainless fixings of the right grade and protected concrete.
Steam room in black mosaic with a starlit ceiling, Istanbul (Turkey)

Compare

Turkish hammam for a Saudi villa or hotel: which option suits

For most Saudi projects we recommend pale dense marble, a hot-water or electric circuit matched to the building, and a sloped ceiling. The table shows when the alternative is better.

DecisionOption 1Option 2Which, and when
MarbleDense white, few poresVeined or colouredWhite on the platform and wet zone; veined on dry feature walls
HeatingHot-water circuitElectric matHot water where a hotel plant exists; electric for a single villa suite
CeilingDomeSloped ceilingDome in a tall hotel hall; slope where the ceiling void is low
Steam sourceHeated platform plus generatorGenerator onlyPlatform softens the steam in busy hotels; generator alone suits a small private room
KurnaSingle marble blockReady-made basinSingle block for long-term hotel use; ready-made only where speed matters most

Design studio

Plan your hammam suite

Pick the layout, the marble and the heat source. We read your choice with the floor plan and reply with a layout.

Layout
Marble
Heat
Plan your hammam suite
4 × 3 mOne suiteWhite marbleHot-water circuit

// 06 · References

Hammams and spas delivered in Turkey

We have not yet completed a project in Saudi Arabia. The hammams and hotel spas below are in Turkey, built by the workshop and crew that would install yours.

All projects

// 07 · Cities and regions

Riyadh, Jeddah, the east and the coast

Riyadh, Jeddah and the Gulf coast each ask for a different steam room, mostly because of humidity and air-conditioning.

  1. Riyadh

    The largest market: private villas, compounds and hotels. Dry heat, strong air-conditioning, careful insulation.

    July 43 °C · January 9 °C · no frost

    Ask about this area
  2. Jeddah

    Red Sea city of hotels and villas. Humid air: ventilation and condensation control come first.

    July 38 °C · January 19 °C · no frost

    Ask about this area
  3. Eastern Province

    Khobar and Dammam: villas and staff housing on the Gulf coast, humid summers.

    July 42 °C · January 12 °C · no frost

    Ask about this area
  4. Red Sea coast resorts

    New resort hotels with spa programmes. Salt air, remote sites, logistics planned in detail.

    August 39 °C · January 12 °C · no frost

    Ask about this area

// 08 · Common mistakes

Mistakes we see in steam rooms across the Gulf

Most failures start with a decision that looked economical and was hidden behind tile. These are the five we meet most.

Steam room with a white mosaic bench, Istanbul (Turkey)
  1. Insulating only the inside face

    Steam reaches the cold wall behind the air-conditioned corridor, condenses and soaks the insulation. Within a couple of years the plaster stains and a musty smell appears. The fix is a continuous vapour barrier on the warm side and insulation that stays dry, planned before the walls are closed.

  2. Generator sized for the floor area

    A generator chosen from floor area alone struggles once marble and glass soak up heat. The room never reaches temperature and the unit runs flat out until it fails. It should be sized from volume, heat loss and the number of users.

  3. Wrong grade of stainless on the coast

    Ordinary stainless fittings pit within a season near the Red Sea or the Gulf, and rust bleeds into the marble joints. Specify the correct marine grade from the start.

  4. Flat floor, no falls

    A floor laid dead flat leaves puddles at the platform, and grout darkens within months. Regrading later means lifting all the marble. The falls belong in the screed and the drain sits where water gathers.

  5. Ordinary door on the steam room

    A standard door swells, leaks steam into the corridor and damps the frame. The corridor air-conditioning then fights the moisture all day. Use a sealed frameless glass door with a threshold seal, designed with the extract.

// 09 · Cost

What drives the cost of hammam construction in Saudi Arabia

The price follows room volume, marble and how much of the building must be adapted, not floor area alone. We price from your plan and photos, so no figures are quoted here.

FactorWhat it changes
Separate men's and women's suitesTwo suites share one plant room, but stone, benches and ventilation double up. Time slots in a single suite cost less to build and less to run.
Marble grade and thicknessDenser pale stone costs more than porous types, and thicker slabs add freight weight. They also keep their colour and hold heat longer in daily hotel use.
Generator and plant roomLarger volume means larger generators, tanks and pumps. A plant room that is easy to reach reduces long-term servicing effort.
Port and inland transportJeddah or Dammam is chosen by site location. Distance from the port to Riyadh or a remote resort adds haulage and handling.
Conformity documentationElectrical items need registration before shipping, so the design must fix the components early. Late changes restart the paperwork.
Local contractor scopeCivil works and licensed electrical connection sit with the local partner. The wider their scope, the fewer lines our quotation carries.

What you receive at handover

  1. Installation drawing set with pipework and drainage diagrams.
  2. Pressure and leak test record, and the commissioning record.
  3. Training for the operator's technicians or the villa owner.
  4. Maintenance plan with a calendar for descaling, seals and ventilation.
  5. Spare parts list with recommended stock.
  6. Equipment certificates and operating manuals.

// 10 · Frequently asked questions

Questions about hammams in Saudi Arabia.

Çilek Havuz Technical Team

Pool & Wellness Engineering

Response Time
Same day
Channels
Phone · Email · WhatsApp

If the answer you are looking for is not here, send your question directly to us and our team will reply as soon as possible.

Request a quotation

Yes. The usual solution is two suites that share one plant room, which saves space on equipment. Smaller villas often choose one suite with a private entrance.

Çilek Havuz Technical Team

In a hot climate most people prefer moist, gentle heat to dry heat. A sauna can still be added next to the steam room; they share the same plant room.

Çilek Havuz Technical Team

Our own installation team. Civil works, the building's electrical supply and licensed local work can go to a Saudi partner or the main contractor, and the split is written in the quotation.

Çilek Havuz Technical Team

Electrical items are registered for conformity before shipping and travel with their certificates. We prepare the technical files and packing lists; the importer of record is the local partner or contractor.

Çilek Havuz Technical Team

Yes. We can deliver the hammam and steam rooms as a complete package under the main contractor, from shop drawings to commissioning.

Çilek Havuz Technical Team

The cost of a Turkish hammam in Saudi Arabia depends on room size, marble and generator capacity. The transport route and the scope left to the local partner also affect it. We give a figure only after seeing your plan, and the quotation itemises every line.

Çilek Havuz Technical Team

Often yes. What matters is a route for the extract to outside, a drain with enough fall, a floor that takes the weight of marble and power for the generator. A site survey confirms this before the design is fixed.

Çilek Havuz Technical Team

Not yet. We work in the Kingdom as a manufacturer and installer shipping from Turkey, and the hammams shown on this page were delivered in Turkey by the same workshop and crew.

Çilek Havuz Technical Team

// 11 · Quotation

Send us your floor plan

Tell us the city, the type of building and whether you need separate areas. We come back with a layout and the questions to settle before pricing.

Phone:+90 216 475 39 37

Are you an installer, dealer or architect in the region? Become a partner

Private hammam in dark marble with a lit octagonal platform
  1. Send the floor plan
  2. Get a layout and scope
  3. Fix the crew dates